Elevation of Biggleswade, England, United Kingdom

Biggleswade, England, United Kingdom is 32 m (105 ft) above sea level.

Biggleswade's height from sea level is 32 metres, or 105 feet. GeoNames reads 32 m at the same point (SRTM).

Ground within 4 km

22 m – 70 m

Mean 38 m across the 8.2 km square centred on the town, 48 m from its lowest cell to its highest.

Rank by elevation

524th of 797

among the towns of England, and 628th of 997 in United Kingdom.

Nearest town

4.8 km to the N, at 29 m, 3 m lower.

Cross-section through Biggleswade

Ground elevation along two lines through the town, 23.2 km end to end, one cell (about 1 km) per step. The red dot is Biggleswade; the vertical scale is the same on both.

7918WE23.2 km
West to east: from 69 m at 12 km west to 35 m at 12 km east.
7918NS23.2 km
North to south: from 22 m at 12 km north to 66 m at 12 km south.
Shaded relief of the 49 km around Biggleswade, drawn from the GMTED2010 grid
Relief, 49 km across, north up; the ring marks the town.

Shading is a north-west light over the grid's own slopes. Colour follows elevation: sea level and below, 0–200 m, 500 m, 1,000 m, 2,000 m, 3,500 m, 5,000 m and above.

Towns near Biggleswade

TownDistanceDirectionElevationCompared
Sandy 4.8 kmN 29 m (95 ft) −3 m
Clifton 6.3 kmSW 45 m (148 ft) +13 m
Henlow-Shefford 7.2 kmSW 41 m (135 ft) +9 m
Baldock 12 kmSE 68 m (223 ft) +36 m
Letchworth 12.3 kmS 85 m (279 ft) +53 m

Peaks and passes near Biggleswade

Summit heights from GeoNames (CC BY 4.0), within 25 km; only summits higher than the town are listed.

Where Biggleswade is

Latitude 52.086938, longitude -0.26422. Open the map here to read the elevation of any point around the town.

Put this on your site

Biggleswade elevation: 32 m (105 ft) above sea level

A small badge with the town's elevation, linking back here. The number updates if the grid reading ever changes.

About this reading

The elevation is the value of the GMTED2010 terrain grid (USGS/NGA, 30 arc-second cells of about 1 km) at Biggleswade's recorded coordinates. It is the height of the ground in that cell, not of any building; a town on a slope spans several cells, and the range above says how much that matters here. GeoNames' reading of 32 m comes from a finer 90 m SRTM grid at the point it records for the town, which may sit a few hundred metres from ours; the two agreeing to within a few metres is the usual case on flat ground, and a larger gap means the ground is steep.