Elevation of Diamond Beach, New South Wales, Australia
Diamond Beach, New South Wales, Australia is 15 m (49 ft) above sea level.
Diamond Beach's height from sea level is 15 metres, or 49 feet. GeoNames reads 20 m at the same point (SRTM).
Ground within 5 km
Mean 16 m across the 9.4 km square centred on the town, 82 m from its lowest cell to its highest.
Cross-section through Diamond Beach
Ground elevation along two lines through the town, 26.6 km end to end, one cell (about 1 km) per step. The red dot is Diamond Beach; the vertical scale is the same on both.
Shading is a north-west light over the grid's own slopes. Colour follows elevation: sea level and below, 0–200 m, 500 m, 1,000 m, 2,000 m, 3,500 m, 5,000 m and above.
Towns near Diamond Beach
| Town | Distance | Direction | Elevation | Compared |
|---|---|---|---|---|
| Hallidays Point | 5.5 km | SW | 27 m (89 ft) | +12 m |
| Old Bar | 9.5 km | NE | 11 m (36 ft) | −4 m |
| Forster-Tuncurry | 16.1 km | S | 4 m (13 ft) | −11 m |
| Taree | 16.4 km | NW | 8 m (26 ft) | −7 m |
| Tinonee | 16.7 km | NW | 22 m (72 ft) | +7 m |
Where Diamond Beach is
Latitude -32.0437641, longitude 152.5377082. Open the map here to read the elevation of any point around the town.
Put this on your site
A small badge with the town's elevation, linking back here. The number updates if the grid reading ever changes.
About this reading
The elevation is the value of the GMTED2010 terrain grid (USGS/NGA, 30 arc-second cells of about 1 km) at Diamond Beach's recorded coordinates. It is the height of the ground in that cell, not of any building; a town on a slope spans several cells, and the range above says how much that matters here. GeoNames' reading of 20 m comes from a finer 90 m SRTM grid at the point it records for the town, which may sit a few hundred metres from ours; the two agreeing to within a few metres is the usual case on flat ground, and a larger gap means the ground is steep.