Elevation of Burrill Lake, New South Wales, Australia

Burrill Lake, New South Wales, Australia is 5 m (16 ft) above sea level.

Burrill Lake's height from sea level is 5 metres, or 16 feet. GeoNames reads 6 m at the same point (SRTM).

Ground within 5 km

0 m – 84 m

Mean 22 m across the 9.3 km square centred on the town, 84 m from its lowest cell to its highest.

Rank by elevation

305th of 326

among the towns of New South Wales, and 941st of 1,000 in Australia.

Nearest town

Kings Point

1.9 km to the N, at 22 m, 17 m higher.

Cross-section through Burrill Lake

Ground elevation along two lines through the town, 26.1 km end to end, one cell (about 1 km) per step. The red dot is Burrill Lake; the vertical scale is the same on both.

West to east: from 140 m at 13 km west to 0 m at 13 km east.

North to south: from 40 m at 13 km north to 0 m at 13 km south.

Shaded relief of the 55 km around Burrill Lake, drawn from the GMTED2010 grid — Relief, 55 km across, north up; the ring marks the town.

Shading is a north-west light over the grid's own slopes. Colour follows elevation: sea level and below, 0–200 m, 500 m, 1,000 m, 2,000 m, 3,500 m, 5,000 m and above.

Towns near Burrill Lake

Town	Distance	Direction	Elevation	Compared
Kings Point	1.9 km	N	22 m (72 ft)	+17 m
Ulladulla	4.4 km	NE	25 m (82 ft)	+20 m
Milton	8.1 km	N	60 m (197 ft)	+55 m
Cunjurong	15 km	NE	19 m (62 ft)	+14 m
Sussex Inlet	29.4 km	NE	6 m (20 ft)	+1 m

Peaks and passes near Burrill Lake

Mount Sydney, peak at 760 m (2,493 ft), 19.9 km to the NW — 755 m above the town.
Pigeon House, peak at 720 m (2,362 ft), 16.6 km to the W — 715 m above the town.

Summit heights from GeoNames (CC BY 4.0), within 25 km; only summits higher than the town are listed.

Where Burrill Lake is

Latitude -35.3885617, longitude 150.4447099. Open the map here to read the elevation of any point around the town.

Put this on your site

<a href="https://www.altitude-maps.com/city/12_149,Burrill+Lake,New+South+Wales,Australia"><img src="https://www.altitude-maps.com/embed/12_149.svg" width="240" height="60" alt="Burrill Lake elevation: 5 m (16 ft) above sea level"></a>

A small badge with the town's elevation, linking back here. The number updates if the grid reading ever changes.

About this reading

The elevation is the value of the GMTED2010 terrain grid (USGS/NGA, 30 arc-second cells of about 1 km) at Burrill Lake's recorded coordinates. It is the height of the ground in that cell, not of any building; a town on a slope spans several cells, and the range above says how much that matters here. GeoNames' reading of 6 m comes from a finer 90 m SRTM grid at the point it records for the town, which may sit a few hundred metres from ours; the two agreeing to within a few metres is the usual case on flat ground, and a larger gap means the ground is steep.