Elevation of Ballyroe, Kildare, Ireland

Ballyroe, Kildare, Ireland is 61 m (200 ft) above sea level.

Ballyroe's height from sea level is 61 metres, or 200 feet. GeoNames reads 61 m at the same point (SRTM).

Ground within 4 km

54 m – 108 m

Mean 63 m across the 8.2 km square centred on the town, 54 m from its lowest cell to its highest.

Rank by elevation

29th of 35

among the towns of Kildare, and 301st of 692 in Ireland.

Nearest town

Kilberry

2.5 km to the NE, at 61 m, the same elevation.

Cross-section through Ballyroe

Ground elevation along two lines through the town, 23 km end to end, one cell (about 1 km) per step. The red dot is Ballyroe; the vertical scale is the same on both.

West to east: from 102 m at 12 km west to 82 m at 12 km east.

North to south: from 65 m at 12 km north to 195 m at 12 km south.

Shaded relief of the 48 km around Ballyroe, drawn from the GMTED2010 grid — Relief, 48 km across, north up; the ring marks the town.

Shading is a north-west light over the grid's own slopes. Colour follows elevation: sea level and below, 0–200 m, 500 m, 1,000 m, 2,000 m, 3,500 m, 5,000 m and above.

Towns near Ballyroe

Town	Distance	Direction	Elevation	Compared
Kilberry	2.5 km	NE	61 m (200 ft)	same
Athy	5.2 km	SE	56 m (184 ft)	−5 m
Stradbally (Laois)	6.5 km	W	83 m (272 ft)	+22 m
Ballylinan (Laois)	8.4 km	S	78 m (256 ft)	+17 m
Nurney	10.9 km	NE	73 m (240 ft)	+12 m

Peaks and passes near Ballyroe

Clogrennan Hill, hill at 336 m (1,102 ft), 23.2 km to the S — 275 m above the town.
Fossy Hill, peak at 322 m (1,056 ft), 13.1 km to the SW — 261 m above the town.
Cullenagh Mountain, peak at 317 m (1,040 ft), 15.8 km to the SW — 256 m above the town.

Summit heights from GeoNames (CC BY 4.0), within 25 km; only summits higher than the town are listed.

Where Ballyroe is

Latitude 53.02, longitude -7.05. Open the map here to read the elevation of any point around the town.

Put this on your site

<a href="https://www.altitude-maps.com/city/100_97,Ballyroe,Kildare,Ireland"><img src="https://www.altitude-maps.com/embed/100_97.svg" width="240" height="60" alt="Ballyroe elevation: 61 m (200 ft) above sea level"></a>

A small badge with the town's elevation, linking back here. The number updates if the grid reading ever changes.

About this reading

The elevation is the value of the GMTED2010 terrain grid (USGS/NGA, 30 arc-second cells of about 1 km) at Ballyroe's recorded coordinates. It is the height of the ground in that cell, not of any building; a town on a slope spans several cells, and the range above says how much that matters here. GeoNames' reading of 61 m comes from a finer 90 m SRTM grid at the point it records for the town, which may sit a few hundred metres from ours; the two agreeing to within a few metres is the usual case on flat ground, and a larger gap means the ground is steep.